Ethernet communicator E16, TRIKDIS

Sends events to monitoring station receiver:

• Sends events to TRIKDIS software or hardware receivers that work with any monitoring software.
• Can send event messages to SIA DC-09 receivers.
• Connection supervision by polling to IP receiver every 30 seconds (or by user-defined period).
• The backup channel, that will be used if connection with the primary channel is lost.
• With parallel communication channels events can be sent to two receivers at the same time.
• When Protegus service is enabled, events are first delivered to CMS, and only then are sent to app users.

Works with Protegus app:

• “Push” and special sound notifications informing about events.
• Remote system Arm/Disarm.

Remote control of connected devices (lights, gates, ventilation systems, heating, sprinklers, etc.).

• Remote temperature monitoring (with iO or iO-WL expanders).
• Different user rights for administrator and installer.

Notifies users:

• Users can be notified about events with Protegus app.

Controllable outputs and inputs:

• 3 double I/O terminals that can be set either as input (IN) or controllable output (OUT) terminals.
• Outputs controlled by the Protegus app.
• Add additional inputs and controllable outputs with wired and wireless iO expanders.

Quick setup:

• Settings can be saved to file and quickly written to other communicators.
• Two access levels for configuring the device for CMS administrator and for the installer.
• Remote configuration and firmware updates.

Specifications

Compatible with

DSC - PC585, PC1404, PC1565, PC1616, PC1832, PC1864, PC5015, PC5020

PARADOX - SPECTRA SP4000, SP5500, SP6000, SP7000, SP65,1727, 1728, 1738, MAGELLAN MG5000, MG5050, DIGIPLEX EVO48, EVO192, EVOHD, NE96, EVO96, ESPRIT E55, 728ULT, 738ULT

*Red - remote Arm/Disarm via Serial bus.