Cellular communicator G16T, 2G, TRIKDIS

Connects to panel’s landline dialer:

• Communicator can be connected to control panel’s landline dialer with 2 or 4 wires
• When connected with 4 wires, the landline between the panel and communicator will be monitored

Sends events to monitoring station receiver:

• Sends events to TRIKDIS software or hardware receivers that work with any monitoring software
• Can send event messages to SIA DC-09 receivers
• Can send event messages to SUR-GARD receivers. The annex has a table for converting Contact ID codes to SIA codes
• Connection supervision by polling to IP receiver every 30 seconds (or by user defined period)
• Backup channel, that will be used if connection with the primary channel is lost
• Events can be reported to CMS with SMS messages. SMS will be sent even if data connection stops working in the mobile operator network
• With parallel communication channels events can be sent to two receivers at same time
• When Protegus service is enabled, events are first delivered to CMS, and only then are sent to app users

Works with Protegus app:

• “Push” and special sound notifications informing about events
• Remote system Arm/Disarm
• Remote control of connected devices (lights, gates, ventilation systems, heating, sprinklers, etc.)
• Different user rights for administrator, installer and user
• Users can also be informed about events with SMS messages and phone calls

Notifies users:

• Users can be notified about events not only with Protegus app, but also with SMS messages and a call

Controllable outputs and inputs:

• 1 output, controlled via:
  • Protegus
  • SMS message
• 2 double I/O terminals that can be set either as input (IN) or controllable output (OUT) terminals
• Add additional inputs and controllable outputs with wired and wireless iO

Quick setup:

• Settings can be saved to file and quickly written to other communicators
• Two access levels for configuring the device for CMS administrator and for installer
• Remote configuration and firmware updates